Note | t
| When installing an exchange cylinder head, all the contact surfaces between the support elements, roller rocker fingers and cams must be oiled before installing the camshaft housing. |
| t
| The plastic protectors fitted to protect the open valves should not be removed until the cylinder head is ready to be fitted. |
| t
| If the cylinder head is replaced, all the coolant in the system must also be changed. |
| t
| Oil the support and slide surfaces before carrying out assembly work. |
| t
| Remove and install intake manifold → Chapter. |
| Distribution chain and distribution pump control chain: removing and fitting → Chapter |
| Removing and fitting the camshaft housing → Chapter |
| Cylinder head: removing and fitting → Chapter |
|
|
|
