Leon Mk2
Assembly overview |
1 - | 10 Nm |
2 - | Camshaft housing cover |
3 - | 10 Nm |
4 - | 10 Nm +1/4 turn further (90º) |
q | Replace |
5 - | Goes to the air filter |
6 - | Hall sender -G40- |
7 - | O-ring |
q | Replace this if it is damaged |
8 - | Support |
9 - | Cylinder head bolt |
q | Replace |
q | Follow installation instructions and sequence when loosening and tightening |
10 - | Roller rocker arms |
q | Check that the roller bearings turn smoothly |
q | Oil contact surface |
q | Use securing clip to clip onto support element when installing |
11 - | Supporting element |
q | Do not confuse |
q | With hydraulic valve clearance compensation. |
q | Oil contact surface |
12 - | Pins |
13 - | Oil pressure switch -F1- 0.3 - 0.7 bar, 25 Nm |
q | Testing → Chapter |
q | If sealing ring is leaking, nip open and replace |
14 - | Cylinder head |
q | Removing and installing → Chapter |
q | Check whether it is damaged → Fig. |
q | The sealing surfaces in contact with the camshaft housing must be free of oil and grease |
q | After replacing, renew coolant completely |
15 - | Cylinder head gasket |
q | Replace |
q | Metal gasket |
q | After replacing, renew coolant completely |
16 - | Guide pin |
q | Tightening torques: 20 Nm |
17 - | 20 Nm |
18 - | Attachment rings |
19 - | Camshaft housing |
q | Removing and installing → Chapter |
q | Remove any sealant remains. |
q | Carefully clean the contact surfaces making sure that they are free of oil and grease |
q | Before mounting, apply D 188 003 A1 |
q | When installing fit vertically from above onto studs and dowel pins |
20 - | Cable guide |
q | Tighten the camshaft housing to a torque of 8 Nm |
|