SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4-cylinder fuel injection, chain transmission | Enginecrankshaft group, pistons | Engine block, flanges | Crankshaft sealing flange, on the flywheel side: replacing | D - Press the sender crown with the assembly device T10134 onto the crankshaft flange

D - Press the sender crown with the assembly deviceT10134 onto the crankshaft flange

D - Press the sender crown with the assembly device -T10134- onto the crankshaft flange

–	Tighten the hexagonal nut of the assembly device -T10134- to a torque of 35 Nm using the torque wrench -V.A.G 1331- and the insertable terminal e/c 24 -V.A.G 1332/11-.

Note

After tightening the hexagonal bolt to 35 Nm, a small space should remain between the engine block and the sealing flange.