Leon Mk2
| Part I Belt system - Assembly overview |
| 1 - | 20 Nm |
| 2 - | Pulley |
| q | For coolant pump |
| q | To loosen and tighten, use the water pump wrench -V.A.G 1590- |
| 3 - | 20 Nm +1/4 turn further (90º) |
| 4 - | 40 Nm |
| 5 - | Washer |
| 6 - | Idler wheel |
| 7 - | Washer |
| 8 - | Spacing sleeve |
| 9 - | Alternator |
| 10 - | 25 Nm |
| 11 - | Spacing sleeve |
| 12 - | Tensioning element |
| 13 - | Pulley |
| q | For crankshaft |
| q | The contact surfaces must be free of oil and grease. |
| 14 - | Securing bolt |
| q | Respect the tightening procedure → Chapter |
| q | Replace |
| q | The contact surface of the fastening bolt must be free of oil and grease |
| q | Apply oil before fitting it (thread) |
| q | Secure the pulley with the counterhold -3415- to prevent it from turning |
| q | Tightening can be done in several stages |
| q | The torque angle can be measured with a Hazet 6690 torque or equivalent |
