Leon Mk2
|
| 1 - | 3 Nm |
Note| t | To attach the upper body of the air filter housing onto the lower one and the suction inlet, use a set of self threading screws. If these screws are loosened or tightened with a screwdriver, the thread of the upper body of the air filter may be damaged. |
| t | For this reason a power tool can only be used when: |
| t | Maximum speed of power tool: 200/min |
| t | Tightening torque is set to a maximum of 3 Nm. |
| 2 - | Air filter housing (upper section) |
| 3 - | Oil seal |
| 4 - | Non-return valve |
| 5 - | Flexible tube |
| q | Goes to the camshaft housing |
| 6 - | Suction line |
| q | with air intake hose |
| 7 - | Spring-type clip |
| q | Remove and fit with the hose clip pliers -VAS 6340- or the spring-type clip pliers -VAS 5024A- |
| 8 - | Oil seal |
| 9 - | Rubber nozzle |
| 10 - | Air filter housing (lower section) |
| q | Removing and fitting → Chapter |
| 11 - | Filter element |
