SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4-Cylinder injection engine (1.4 l engine) | Enginecrankshaft group, pistons | Engine block, flanges | Crankshaft sealing flange, on the flywheel side: replacement | B - Fit the installation device T10134 with the sealing flange on the crankshaft flange

B - Fit the installation deviceT10134 with the sealing flange on the crankshaft flange

B - Fit the installation device -T10134- with the sealing flange on the crankshaft flange

l	The crankshaft flange must be free of oil and grease.

l	The engine should be in TDC cylinder 1.

–	Screw in the hexagonal bolt -B- to the end of the threaded spindle.

–	Press the threaded spindle of the assembly device -T10134- in the direction of the arrow until the hexagonal nut -B- is in contact with the installation socket -A-.

–	Point the flat part of the installation socket towards the sealing surface of the engine block in contact with the oil sump.

–	Secure the fitting device -T10134- to the crankshaft flange; to do so, tighten the Allen bolts -A- about

Note

Screw the Allen screws -A- by approx. 5 threads into the crankshaft flange.

–	Screw in the 2 bolts M6×35 mm -A- on the engine block to guide the sealing flange.