seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Exhaust gas recirculation system > < Silencers with suspension elements - Components overview
Separate the main and rear silencers .
Separate the main and rear silencers .
t  In order to replace the front and rear silencers separately, the exhaust pipe can be cut at the marked point.
t  The cutting area is marked.
Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Plate work saw -V.A.G 1523 A-, see equivalent → Anchor
t  Protective glasses
  WARNING
Wear safety goggles and appropriate clothing to avoid injury caused by metal shavings.
  W00-0005
–  Cut the exhaust pipe at right angles at separating point -arrow 2- with the hack saw -V.A.G 1523 A-.
–  When installing, position clamp -4- at the marks -arrow 1- and -arrow 3-.
  A26-0732
–  Install the clamp so that the bolt end does not project over the clamp lower edge.
l  Screw thread must face rear
–  Align exhaust system cold and free of tension.
  A26-0159

Exhaust gas recirculation system > < Silencers with suspension elements - Components overview