Leon Mk2
| Fuel rail with injectors - Assembly overview |
| 1 - | O ring |
| q | replace |
| q | Before installing moisten with clean engine oil |
| 2 - | Elastic element |
| q | Replace every time the lower part of the intake manifold is removed |
| q | Check for correct fit on injector |
| 3 - | Injector, cylinder 4 -N33- |
| q | Injector, cylinder 1 -N30- |
| q | Injector, cylinder 2 -N31- |
| q | Injector, cylinder 3 -N32- |
| q | With Teflon seal and support washer. |
| q | After removing injector, Teflon seal and support washer must be renewed → Chapter. |
| q | Removing and installing injectors → Chapter. |
| 4 - | Lower part of intake manifold |
| q | To remove and install: using "bracket for bits 5/16""" -V.A.G 1766/2- and Bit -3320/2- → Fig. |
| q | To remove: removing and installing regulating flap control unit -J808-, throttle valve module -J338- and intake manifold → Chapter. |
|
|
