Leon Mk2
Cooling system, bodywork side: removing and fitting |
1 - | Spring type clips |
2 - | Upper coolant hose |
q | Note the fitting position |
q | Diagram of coolant hose connections → Chapter |
3 - | Coolant hose |
4 - | 10 Nm |
5 - | Plug |
q | Check with cooling system tester -SAT 1274- and adaptor -VAG 1274/9- |
q | Opening pressure: 1.4 - 1.6 bar |
6 - | Expansion tank |
q | Perform cooling system leakage check with cooling system tester -SAT 1274- and the adaptor -VAG 1274/8- |
7 - | Towards thermostat cover |
q | Diagram of coolant hose connections → Chapter |
8 - | Mounting |
q | Bolt: 10 Nm |
q | For radiator |
q | Note the fitting position |
9 - | Air duct |
10 - | 10 Nm |
11 - | Lower coolant hose |
q | Check firm seating |
q | Diagram of coolant hose connections → Chapter |
12 - | Spring type clip |
13 - | Rubber receiver |
14 - | Electric ventilator |
15 - | Connector |
16 - | Radiator fan thermoswitch -F18-, 35 Nm |
q | For the radiator fan |
Switching temperatures |
1a speed |
q | Connect: 92 … 97 ? |
q | Disconnect: 84 … 91 °C |
2a speed |
q | Connect: 99 … 105 ? |
q | Disconnect: 91 … 98 °C |
17 - | Radiator |
q | Removing and installing → Chapter |
q | After replacing, renew coolant completely |