Leon Mk2
Cooling system, engine side: removing and fitting |
1 - | Towards the upper part of the expansion tank |
q | Diagram of coolant hose connections → Chapter |
2 - | O-ring |
q | Replace if damaged or worn |
3 - | To heat exchanger |
q | Diagram of coolant hose connections → Chapter |
4 - | Connector |
q | 2 pins |
5 - | Coolant temperature sender -G62- |
q | For engine control unit |
q | Before removing, possibly reduce cooling system pressure |
6 - | Securing clip |
q | Check firm seating |
7 - | Coolant pipe |
q | Diagram of coolant hose connections → Chapter |
8 - | From ATF radiator (automatic gearbox only) or formed pipe |
q | Diagram of coolant hose connections → Chapter |
9 - | Bolt, 40 Nm |
10 - | Nut, 10 Nm |
11 - | Towards the lower part of the expansion tank |
q | Diagram of coolant hose connections → Chapter |
12 - | O-ring |
q | Replace if damaged or worn |
13 - | From ATF radiator (automatic gearbox only) or formed pipe |
q | Diagram of coolant hose connections → Chapter |
14 - | Connection nozzle |
q | Diagram of coolant hose connections → Chapter |
15 - | To radiator, upper part |
q | Diagram of coolant hose connections → Chapter |
q | Check for secure seating |
16 - | Comes from the bottom of radiator |
q | Diagram of coolant hose connections → Chapter |
q | Check for secure seating |
17 - | Bolt, 15 Nm |
18 - | Connection nozzle |
q | Diagram of coolant hose connections → Chapter |
19 - | Coolant thermostat |
q | Check: heat the thermostat in water |
q | Approx. commencement of opening 87 ? |
q | End: approx. 102 °C |
q | Opening distance: at least 7 mm |
q | Removing and installing → Chapter |
20 - | Notched belt |
q | Mark direction of rotation before removing |
q | Check for wear |
q | Do not kink. |
q | removing, installing and tightening → Chapter |
21 - | Front of coolant pump |
q | Check for ease of movement |
q | If damaged or leaking: replace completely |
q | Removing and installing → Chapter |
22 - | Rear notched belt guard |
23 - | Bolt, 20 Nm |
24 - | Washer |