Leon Mk2
Part IV |
Note
Clutch repairs: → Rep. Gr.30. |
1 - | 90 Nm +1/4 turn (90º) |
q | Replace |
q | Use counterhold -T20018B- to loosen and tighten |
q | Thread and collar must be free of oil and grease. |
2 - | Timing belt-crankshaft sprocket |
q | There must be no oil on the contact surface between the toothed belt and the crankshaft |
3 - | 15 Nm |
4 - | Oil seal |
q | Renew → Chapter |
q | Do not use oil |
5 - | Sealing flange |
q | removing and installing → Chapter |
q | Fit with silicon-based sealant -D 176 404 A2- → Chapter |
6 - | Engine block |
q | Crankshaft: removing and installing → Chapter |
q | Piston and piston rod: removing and installing → Chapter |
7 - | 60 Nm +1/4 turn (90º) |
q | Replace |
q | Use the extractor -T20076- to loosen and tighten |
8 - | Engine flywheel |
q | Removing and installing → Chapter |
9 - | Intermediate plate |
q | Do not bend or damage during fitting work |
q | Installation position → Fig. |
10 - | Sealing flange with sealing ring |
q | Always replace assembly |
q | Do not use oil |
q | Make sure the oil seal lip is not damaged or bent on fitting |
q | To fit, insert the guide sleeve (supplied with the seal) on the crankshaft |
q | The oil sump must be removed when stripping and fitting → Chapter |
|