Adjust accelerator cable by moving retainer -arrow- at the support bracket, so that the full throttle position is attained at the throttle valve control module cable cam.
Vehicles with 4-speed automatic gearbox 099
Special tools and workshop equipment required
t
Hand multimeter -V.A.G 1526C-
t
Auxiliary measuring set -V.A.G 1594C-
t
Spacer, 13 mm
Procedure
–
Clamp spacer -1-, a = 13 mm, between accelerator pedal -2- and stop -3-, and hold accelerator pedal in this position.
–
Open throttle valve fully by pulling on accelerator cable sleeve and lock in this position with retainer -arrow-.
–
Release accelerator pedal
–
Pull 2-pin connector off kick-down switch -F8- in front of engine compartment (on the bulkhead).
–
Connect hand multimeter -V.A.G 1526C- to kick-down switch -F8- using auxiliary cables from adapter set -V.A.G 1594C-.
–
Check resistance at switch. Specification: ∞∼Ω
–
Slowly move accelerator pedal in direction of full throttle.
Shortly after the kick-down pressure point the resistance must drop to 0 Ω. At this point the accelerator pedal must be just off the stop.