–
| Lubricate threaded head of oil seal extractor -3203-, place in position and exerting firm pressure, screw it as far as possible into oil seal. |
–
| Loosen knurled screw and turn inner part against crankshaft until the oil seal is pulled out. |
Note Gradual introduction of PTFE seals (polytetrafluoroethylene) Characteristics: no coil spring, wider sealing lip. The sealing lip of this oil seal must not be additionally oiled or greased. A older design radial shaft seal (with coil spring) may be replaced by a PTFE seal, but not the other way around. |
–
| Remove oil residue from crankshaft journal using a clean cloth. |
Installing oil seal with coil spring |
–
| Lightly oil sealing lip of oil seal. |
|
|
|