SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Fuel supply, gas operation >
< Cooling system: checking seal
Leon Mk2
Power unit
4-cylinder TDI diesel engine with pump injector unit, 2.0 litre and 2v, mechanics
Engine cooling / Parts of cooling system: Removing and installing
Radiator fan V7 and fan 2 of the radiator V177 : Removing and installing
Radiator fanV7 and fan 2 of the radiatorV177: Removing and installing
Radiator fan -V7- and fan 2 of the radiator -V177-: Removing and installing
t
Removing
→ Anchor
t
Fitting
→ Anchor
t
Tightening torques
→ Anchor
Removing
–
Detach the outer
-1-
and inner
-2-
engine covers, by pulling them evenly upwards.
–
Remove the air intake hose
-arrow-
between the lock carrier plate and the air filter housing.
–
Unscrew air duct at lock carrier
-arrows-
.
–
Remove the centre noise insulation, fastening points
-1 … 3-
→ Bodywork, exterior fitting work; Rep. Gr.50
.
–
Remove air hose (right-side) by lifting retaining clips
-arrows-
slightly.
–
Unplug connector
-1-
.
–
Extract the bolts of the fan cowl
-arrows-
.
–
Remove the fan cowl downwards.
–
Unplug connector
-1-
.
–
Lay bare cables.
–
Unscrew nuts
-arrows-
and take radiators out.
Installing
Fit in reverse order from removal, remembering the following:
Fit the supercharger air system hoses and observe the assembly instructions
→ Chapter
Tightening torques
Component
Nm
Radiator fan to fan cowl
10
Fan cowl to radiator
5
Power unit
4-cylinder TDI diesel engine with pump injector unit, 2.0 litre and 2v, mechanics
Engine cooling / Parts of cooling system: Removing and installing
Radiator fan V7 and fan 2 of the radiator V177 : Removing and installing
Fuel supply, gas operation >
< Cooling system: checking seal