SEAT Workshop Service and Repair Manuals

Bracket for auxiliary units: Removing and installing t  Removing → Anchor t  Fitting → Anchor t  Tightening torques → Anchor Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter Special tools and workshop equipment required

t  Tightening torque -VAG 1331-, see equivalent → Anchor

t  Counterhold -T10038-, see equivalent → Anchor

Removing –  Detach the outer -1- and inner -2- engine covers, by pulling them evenly upwards.   WARNING Observe safety precautions when disconnecting the battery → Electrical system; Rep. Gr.27. –  Disconnect earth wire at battery with ignition switched off.

–  Release the fuel and coolant hoses from their fittings on the air duct. –  Remove bolt -1-. –  Remove air duct by lifting retaining clips -arrows- slightly. –  Remove poly V-belt → Chapter.

–  Extract the fuel filter bracket by pulling upwards -arrow- with the hoses connected.

–  Unplug connector -2-. –  Unscrew the electrical cable nut -1- and the cable bracket.

–  Screw out bolts -arrows- and remove alternator.   WARNING The air conditioning cooling circuit must not be opened.   Note To prevent damage to the air conditioning compressor and refrigerant pipes/hoses, ensure that the pipes and hoses are not stretched, kinked or bent.

–  Disconnect electrical connection -1- for magnetic coupling on air conditioner compressor. –  Remove compressor bolts -arrows-.

–  Suspend the air conditioner compressor above with refrigerant hoses still connected, securing it with the securing tool -T10038- to the lock carrier plate. Take special care not to damage the system. –  Remove the engine assembly lifting rings on the engine side.

–  Remove the auxiliary bracket -bolts 1 … 6-. Installing: Fit in reverse order from removal, remembering the following: –  Check whether dowel sleeves for aligning the ancillaries bracket are fitted in cylinder block and install sleeves if necessary. –  Tighten the bolts in the sequence -1 … 6-. –  Install the air conditioner compressor → air conditioning system; Rep. Gr.87. –  Install the alternator → Electrical system; Rep. Gr.27. –  Connect battery. Precautions → Electrical system; Rep. Gr.27. Tightening torques

Component		Nm
Bracket for auxiliary units on engine block		45