Leon Mk2
Exhaust system: Rear silencers on vehicles with all-wheel drive - Assembly overview |
1 - | Suspension |
q | If this is damaged, replace it |
2 - | Mounting |
q | If this is damaged, replace it |
3 - | 23 Nm |
4 - | 23 Nm |
5 - | Front clamp |
q | Align exhaust system so it is free of stress before fixing it |
q | Installation position → Fig. |
q | Tighten bolted connections evenly. |
6 - | Suspension |
q | If this is damaged, replace it |
7 - | Mounting |
q | If this is damaged, replace it |
8 - | 23 Nm |
9 - | Bracket |
q | If this is damaged, replace it |
10 - | 23 Nm |
11 - | Bracket |
q | For particle filter |
12 - | 23 Nm |
13 - | 23 Nm |
14 - | Securing clip - 7 Nm |
q | Replace. |
15 - | Gasket |
q | Replace. |
16 - | Particulate filter for vehicles with all-wheel drive |
q | Removing and installing → Chapter |
q | Following replacement of the particle filter, the “guided functions” → Vehicle diagnosis, testing and information system VAS 5051 must be adapted. |
17 - | Vehicle floor front cross member |
18 - | 23 Nm |
19 - | 23 Nm |
20 - | Mounting |
q | If this is damaged, replace it |
21 - | 23 Nm |
22 - | Rear silencer |
q | Align exhaust system without tension → Chapter |
23 - | Suspension |
q | If this is damaged, replace it |
24 - | Bracket |
q | If this is damaged, replace it |
25 - | 23 Nm |
|