seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Intake manifold: removing and installing > < Intake manifold with flap motor - assembly overview

Leon Mk2

Intake manifold flap motorV157: Removing and installing
Intake manifold flap motor -V157-: Removing and installing
t  Removing → Anchor
t  Fitting → Anchor
t  Tightening torques → Anchor
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Tightening torque -VAG 1331-, see equivalent → Anchor
  W00-0427
Removing
–  Detach the outer -1- and inner -2- engine covers, by pulling them evenly upwards.
  E10-10038
–  Release the fuel and coolant hoses from their fittings on the air duct.
–  Remove bolt -1-.
–  Remove air duct by lifting retaining clips -arrows- slightly.
  A10-10266
–  Detach electrical connector -1- of the engine intake manifold flap -V157-.
–  Unscrew the bolts -arrows- and remove the intake manifold flap motor -V157-.
Installing
Fit in reverse order from removal, remembering the following:
  Note
t  Replace gaskets and seals.
t  Secure all hose connections with the correct hose clips (original parts) → ETKA (Electronic parts catalogue).
Fit the supercharger air system hoses and observe the assembly instructions → Chapter
Tightening torques
  A10-10029
ComponentNm
Intake manifold flap motor -V157- to the intake manifold10

   

Intake manifold: removing and installing > < Intake manifold with flap motor - assembly overview