Leon Mk2
|
| 1 - | 26 Nm |
| 2 - | Securing strap |
| q | Removing and fitting → Chapter |
| q | Installation position: Fixing point (holes) point in direction of travel |
| 3 - | Heatshield |
| q | For fuel tank |
| q | May change size depending of model |
| 4 - | Fuel supply line |
| q | Black colour |
| q | To fuel filter |
| q | Do not bend the belt |
| q | Install on fuel tank |
| 5 - | Fuel return line |
| q | Blue colour |
| q | To fuel radiator |
| q | Do not bend the belt |
| q | Install on fuel tank |
| 6 - | Electric connector |
| q | For fuel pump (pre-supply pump) -G6- and fuel gauge sender -G- |
| 7 - | Gasket |
| q | If this is damaged, replace it |
| 8 - | Plug |
| q | Held using anti-loss fastener on the fuel tank cover unit |
| 9 - | Earth connection |
| q | To divert electrostatic charge |
| q | Installation position → Fig. |
| q | Ensure that connector is seated properly and secure lines with the collared securing bolt for fuel filler neck → Item |
| q | After installation, use an ohmmeter to check the electrical connection between the metal ring on the fuel filler neck and a bare metal part on the body - specification: approx. 0 Ω |
| 10 - | Seal bolt -11 Nm |
| q | Secures fuel filler neck and earth connection |
| 11 - | Fuel tank |
| q | Removing and fitting → Chapter |
| 12 - | 26 Nm |
| 13 - | Lock washer |
| q | Removing: Turn to the left |
| q | Installing: Tighten to 2 Nm |
|
|
WARNING