Leon Mk2
| Block, crankshaft oil seal and engine flywheel/traction disk: disassembly and assembly |
| Clutch repairs: → Rep. Gr.30. |
| 1 - | Intermediate shaft seal |
| q | Removing and fitting → Chapter |
| 2 - | Pin |
| q | Check if it is seated properly |
| 3 - | 25 Nm |
| 4 - | Crankshaft oil seal |
| q | Removing and fitting → Chapter |
| 5 - | Gasket |
| q | Replacement |
| 6 - | Cylinder block |
| q | Crankshaft → Chapter |
| q | Piston and piston rod → Chapter |
| 7 - | 60 Nm + 1/4 turn (90°) |
| q | Replacement |
| 8 - | Plate |
| q | Note the fitting position |
| 9 - | Clutch press |
| q | Removing and fitting → Fig. |
| 10 - | Engine flywheel |
| q | To remove and fit, immobilise using the -T20075A- tool |
| 11 - | Intermediate plate |
| q | Should slot into the adjustment sleeves |
| q | Do not damage/bend when assembling |
| 12 - | Crank shaft oil seal with seal |
| q | Only renew complete |
| q | To remove, extract the clutch press → Fig. |
| q | Lubricate carefully the lip of the seal |
| 13 - | 10 Nm |
| 14 - | Crankshaft bearing seal |
| q | Replace → Chapter |
| 15 - | Intermediate shaft |
| q | Removing and fitting → Chapter |
| 16 - | O-ring |
| q | Replace if damaged |
| 17 - | Oil seal for the intermediate shaft |
