seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Radiator: Removing and installing > < Removing

Leon Mk2

Fitting
Fitting
Installation is carried out in the reverse sequence, when doing this note the following:
–  Clean the sealing surface for the O-ring.
   
–  Moisten the new O-ring -5- with coolant.
–  Insert coolant pump -4- into cylinder block and tighten securing bolts -3-. Tightening torques: 15 Nm
–  Replace the securing bolt -1- for the idler roller -2- and fit the idler roller. Tightening torques: 40 Nm + 1/4 turn (90 °)
Installing toothed belt and adjusting valve timing → Chapter
–  Install ribbed belt → Chapter.
–  Fill with coolant → Chapter
  A19-0028

Radiator: Removing and installing > < Removing