–
| Press the toothed belt firmly with thumb. The groove and the projection -arrow- should move. |
–
| Release tension on toothed belt. The tensioning roller should return to its original position (the notch and the lug coincide again). |
–
| If the groove and the lug do not coincide, loosen the tensioning roller and adjust the tension on the toothed belt → Chapter, Toothed belt: removing, installing and tensioning. |
–
| If the tension on the toothed belt has been changed: |
–
| Check and if necessary adjust dynamically the beginning of injection → Chapter, Components and functions: adapting |
|
|
|