seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Sealing flange, pulley side: removing and installing > < Removing

Leon Mk2

Fitting
Fitting
  Note!
Gradual introduction of PTFE oil seals (identifying characteristics: no annular spring, wider sealing lip). The lip of this seal must not be lubricated with oil or grease. A radial shaft seal of older design (with annular spring) may be replaced with a PTFE oil seal, but not vice versa.
   
–  Before installing, remove oil traces from crankshaft journal with a clean cloth.
–  Fit the seal onto guide sleeve -T20081B/6- and fit the unit on the camshaft stub.
–  Use fitting tool -T20081B/1- and press guide sleeve-oil seal set as far as it will go. For this use the old camshaft sprocket securing bolt.
  E13-0113
–  Install crankshaft toothed belt sprocket and lock with counter-hold -T20018A-.
  Note!
Thread and shoulder must be free of oil and grease.
Installing toothed belt and adjusting valve timing → Chapter
–  Install ribbed belt → Chapter.
  E13-0016

Sealing flange, pulley side: removing and installing > < Removing