Leon Mk2
Part I |
1 - | Upper toothed belt shield |
2 - | 20 Nm |
3 - | Return belt tensioning roller |
q | Test → Chapter |
q | Tighten the toothed belt → Chapter |
4 - | Toothed return belt |
q | Mark the direction of rotation before removing it |
q | Check for wear |
q | Do not bend |
q | Toothed belt routing → Fig. |
q | Remove and install, tighten → Chapter |
5 - | 20 Nm |
6 - | Rear toothed belt shield |
7 - | 12 Nm |
8 - | 20 Nm |
9 - | Hanging ring |
10 - | 25 Nm |
11 - | Return roller |
12 - | Support |
13 - | 50 Nm |
14 - | Gasket |
q | The gasket may be integrated into the pump forming a single unit |
15 - | Coolant pump |
q | In the event of a fault or leakage, replace the whole unit |
q | Remove and install → Chapter |
16 - | Main belt tensioning roller |
q | Test → Chapter |
q | Tighten the toothed belt → Chapter |
17 - | Main toothed belt return roller |
18 - | 50 Nm |
19 - | Toothed belt-crankshaft pinion |
q | Check the position when installing the toothed belt → Chapter |
20 - | 20 Nm |
21 - | Main toothed belt |
q | Mark the direction of rotation before removing it |
q | Check for wear |
q | Do not bend |
q | Toothed belt routing → Fig. |
q | Remove and install, tighten → Chapter |
22 - | Pulley |
q | Check the fastening when fitting |
q | Remove and install → Chapter |
q | Remove and install the Poly-V belt → Chapter |
23 - | 90 Nm + 1/4 turn (90°) |
q | Replace |
q | Fit lubricated |
q | The tightening may be carried out in several stages |
q | The tightening angle can be measured with the -T20030- |
24 - | Poly-V belt |
q | Mark the direction of rotation before removing it |
q | Remove and install → Chapter |
q | Poly-V belt routing → Anchor |
q | Vehicles with air conditioning have an additional return roller |
25 - | Lower toothed belt shield |