Leon Mk2
Part II |
Note!
Clutch repairs: → Rep. Gr.30. |
1 - | Engine block |
q | Disassembly and assembly of the aluminium engine block → Chapter |
q | Piston and connecting rod: disassembly and assembly → Chapter |
2 - | 50 Nm |
q | Tightening order: First tighten the upper right bolt, then the lower right and, finally, the left bolts (looking forward) |
q | Replace |
3 - | Oil filter |
q | Loosen by the hexagon or with a universal filter extractor (-U-40078-) |
q | Hand tighten |
q | Follow the installation instructions on the filter |
4 - | M8: 20 Nm + 1/4 turn (90°) M10: 45 Nm |
5 - | Support |
q | To the vane pump and the alternator |
q | For vehicles without air conditioning |
q | Remove and install the support for vehicles with air conditioning: → Rep. Gr.87 |
6 - | 13 Nm |
q | Loosen and tighten the bolts on the flywheel side with the box spanner -U-40051- |
7 - | Oil sump |
q | Remove and install → Chapter |
8 - | Ring gasket |
q | Replace |
q | On engines with screw-ring gasket unit, replace the bleed screw |
9 - | Oil bleed screw, 30 Nm |
q | Replace on engines with screw-ring gasket unit |
10 - | 45 Nm |
11 - | Washer |
12 - | Tensioning roller |
13 - | Tensioning element |
|