Leon Mk2
Assembly diagram |
1 - | 6 Nm + 1/4 turn (90o) |
q | Replace |
q | Bear in mind the fitting instructions and loosening and tightening order → Chapter |
2 - | Protective hood |
3 - | Sleeve |
q | Replace if worn |
4 - | Plug |
q | Replace the gasket if worn |
5 - | Cylinder head cover |
q | Sealing surfaces may not be re-cut |
q | With camshaft bearings incorporated |
q | Removing and fitting → Chapter |
q | Eliminate all sealant residues |
q | Coat with -AMW 154 103- before positioning |
q | Fit vertically from above in the equidistant cylinder head holes with the adjustment bushings |
6 - | Hose |
q | Goes to the air filter |
7 - | Fixing clip |
q | With support |
q | For hose → Item |
8 - | 10 Nm |
9 - | Support |
q | For wiring harness |
10 - | Pin |
11 - | Camshaft |
q | Test the axial play → Fig. |
q | Identification and distribution timing → Fig. |
q | Lubricate the slip surfaces |
q | Removing and fitting → Chapter |
12 - | 20 Nm |
13 - | Cylinder head bolt |
q | Replace |
q | Bear in mind the fitting instructions and loosening and tightening order → Chapter |
14 - | Suspension ring |
15 - | Cylinder head |
q | Check for deformation → Fig. |
q | After replacing, drain coolant completely and refill |
q | Removing and fitting → Chapter |
q | Camshaft side sealing surfaces may not be re-cut |
16 - | Floating rocker arm |
q | Check that the roller bearings turn smoothly |
q | Lubricate the slip surface |
q | To fit, clip it with the safety clip on the support element |
17 - | Safety clip |
18 - | Support element |
q | Do not swap |
q | With hydraulic compensation of the valve play |
q | Before fitting check the axial play of the camshaft → Fig. |
q | Lubricate the slip surface |
19 - | Cylinder head gasket |
q | Metal gasket |
q | Replace |
q | After replacing, drain coolant completely and refill |
20 - | Seal |
q | Lightly lubricate the sealing lip of the seal |
q | Replace → Chapter |
|