Leon Mk2
|
| 1 - | Throttle valve module -J338- |
| q | If the throttle valve control unit is replaced, the new control unit must be adapted to the engine control unit → Chapter; Functions and components: adapting. |
| q | In vehicles fitted with an automatic gearbox, it is also necessary to adapt the gearbox control unit → Chapter; Functions and components: adjusting |
| q | Cleaning → Chapter |
| 2 - | 10 Nm |
| 3 - | Gasket |
| q | Only for vehicles up until the year model 2004 |
| q | Not the installation position |
| q | Renew |
| 4 - | Suction inlet |
Note| After the model year 2004 the air inlet is integrated in the intake manifold. |
| 5 - | O-ring |
| q | Replace if damaged |
| 6 - | 20 Nm |
| 7 - | Gasket |
| q | Renew |
| 8 - | Guide plate |
| q | Note installation position |
| q | Replace if damaged |
| 9 - | O-ring |
| q | Replace if damaged |
| 10 - | 3 Nm |
| q | For the engines BKY, BXW the component is incorporated with the intake manifold using a clip |
| 11 - | Intake manifold pressure sender -G71-with air intake temperature sender -G42- |
| q | For the BKY, BXW engines, open and close the attachment clip carefully |
| q | Resistance values of the Intake air temperature sender -G42- → Fig. |
| 12 - | Intake manifold |
| q | Injection system - Components overview → Chapter |
