seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing coolant pipe (rear right) > < Removing and installing coolant pipe (top left)

Leon Mk2

Removing and installing coolant pipe (bottom left)
Removing and installing coolant pipe (bottom left)
t  Removing → Anchor
t  Fitting → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Pliers for spring-loaded band-type clamps -VAS 6499-, see equivalent → Anchor
  W00-10700
Removing
–  Remove engine cover panel -arrows-.
–  Drain coolant → Chapter.
  E10-10127
–  Release hose clips -arrows- and remove air hose.
  Note
Ignore -item 1-.
  A21-10302
–  Release hose clip -3-, lift retaining clip -2- and detach coolant hoses.
–  Remove bolt -1- and pull coolant pipe (bottom left) off 4/2-way valve.
Installing
Reassembly is carried out in the reverse order; note the following:
l  Tightening torque → Chapter „Coolant lines, coolant temperature senders, coolant circulation pump: Assembly overview“
  Note
t  Replace seals.
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Parts catalogue.
–  Install air hoses with screw-type clips → Fig..
–  Connect coolant hose with plug-in connector to coolant pipe → Fig.
–  Fill up coolant → Chapter.
  A19-11219

Removing and installing coolant pipe (rear right) > < Removing and installing coolant pipe (top left)