seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Sealing flange on the pulley side Assembly overview > < Removing and installing ancillary bracket

Leon Mk2

Removing and installing vibration damper
Removing and installing vibration damper
t  Removing → Anchor
t  Fitting → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Adjustment tool -T40098-, please see Correspondence → Anchor
  W00-10333
Removing
–  Loosen quick-type locks -1 and 2- and remove front noise insulation.
–  Remove front bumper cover → Rep. gr.63.
–  Move lock carrier to service position → Rep. gr.50.
–  Remove poly V-belt → Chapter.
–  Remove vibration damper cover.
  A10-1320
–  Unscrew the bolts -Arrows- of the vibration dampers. Also, counterhold the vibration damper to the middle bolt with a ring spanner.
–  Remove vibration damper .
Installing
Reassembly is carried out in the reverse order; note the following:
l  Tightening torque → Chapter „Assembly overview - poly V-belt drive“
–  When installing the vibration damper, use only new genuine bolts (same as original equipment): → Spare parts catalogue.
  A13-10644
l  Can only be fitted in one position: The borehole of the vibration damper must be positioned above the raised section of the toothed belt sprocket -arrow-.
  A13-0134

Sealing flange on the pulley side Assembly overview > < Removing and installing ancillary bracket