–
| Disengage the connector -3- of the Lambda probe -G39- and move the electric wiring clear. |
–
| Screw out the Lambda probe -G39--1- using the wrench -3337/1-. |
Note -Items 2 and 4- can be disregarded. |
Reassembly is carried out in the reverse order; note the following: |
Note t
| The screw thread on the new lambda probe is coated with a special paste; the paste must not get into the slots on the probe body. |
t
| In the case of a used Lambda probe grease only the thread with high-temperature paste. The paste must not get into the slots on the Lambda probe body. For high-temperature paste refer to → Parts catalogue. |
t
| When installing, the Lambda probe wiring must always be re-attached at the same locations to prevent it from coming into contact with the exhaust pipe. |
|
|
|