| Removing and installing parts of exhaust system |
Note | t
| The connection element on the primary exhaust tube should not be bent more that 10 º, otherwise it may be damaged. |
| t
| After working on the exhaust system, ensure that the system is not under tension and that there is sufficient clearance to the bodywork. If necessary, loosen the double and securing clamps and position the silencer and exhaust tube in such a way that there is sufficient distance from the body and the supports are evenly loaded → Chapter. |
| t
| Removing and installing exhaust manifold → Chapter. |
| t
| Renew self-locking nuts. |
| t
| Exhaust pipe front section with particle filter: Assembly overview → Chapter |
| t
| Front exhaust section with the particle filter: Removing and installing → Chapter |
| t
| Lambda probe -G39-: removing and fitting → Chapter |
| t
| Exhaust gas temperature sender 2 -G448-: removing and fitting → Chapter |
| t
| Temperature sensor behind the particle filter -G527-: removing and fitting → Chapter |
| t
| Stress-free alignment of exhaust system → Chapter |
|
|
|
