Leon Mk2
Note
|
1 - | 20 Nm + 90° (1/4 turn) further |
q | Replace |
2 - | Rocker axle |
q | removing and fitting → Chapter |
3 - | Counternut |
4 - | Slotted bolt |
q | Replace this when fitting a new injector pump if there are signs of wear |
q | Grease the contact surface with the injector pump sphere head pin → Parts Catalogue |
5 - | Ball head stud |
q | Replace |
6 - | Injector pump |
q | Check if the sphere head pin has traces of wear; replace it if necessary |
q | Grease the contact surface with the adjustment screw → Parts catalogue |
q | removing and fitting → Chapter |
7 - | O ring |
q | replace → Chapter |
8 - | O ring |
q | replace → Chapter |
9 - | O ring |
q | replace → Chapter |
10 - | Heat proof joint |
q | Replace |
11 - | Securing clip |
12 - | Cylinder head |
13 - | Clamping block |
14 - | 12 Nm + 270° (3/4 turn) further |
q | Replace |