seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing coolant temperature sender at radiator outletG83 > < Removing and installing right coolant pipe

Leon Mk2

Coolant temperature senderG62: Removing and installing.
Coolant temperature sender -G62-: Removing and installing.
Special tools and workshop equipment required
   
t  Removal lever -80 - 200-
  W00-0353
Removing
l  Engine cold
–  Briefly open filler cap for coolant expansion tank in order to reduce pressure in cooling system.
–  Remove engine cover → Chapter.
–  Remove air filter housing → Chapter.
–  Remove noise insulation → Rep. gr.50.
  A02-0061
–  Remove bolts -arrows-.
–  Free electrical lines and hoses on left air pipe using removal lever -80 - 200-.
–  Loosen hose clip -3- and press left air pipe with coolant pipe aside.
  A21-10493
–  Pull connector -4- off coolant temperature sender -G62-.
  Note
Place a cloth underneath connection to catch escaping coolant.
–  Pull off retaining clip -3- and pull coolant temperature sender -G62- out of screw connection.
Installing
Installation is carried out in the reverse order; note the following:
  Note
t  Renew O-ring.
t  Insert new coolant temperature sender -G62- immediately into union to avoid loss of coolant.
–  Check coolant level and top up if necessary → Chapter.
  A19-10992

Removing and installing coolant temperature sender at radiator outletG83 > < Removing and installing right coolant pipe