SEAT Workshop Service and Repair Manuals

Removing and installing right coolant pipe Special tools and workshop equipment required

t  Hose clamps up to 25 mm -3094-

t  Drip tray for workshop hoist -VAS 6208-

t  Hose clip pliers -VAS 6362- Removing –  Remove engine cover → Chapter.

–  Unscrew bolts and nuts -arrows-. –  Move fuel filter clear to one side (fuel hoses remain connected). –  Remove noise insulation → General body repairs, exterior; Rep. gr.50. –  Remove front right wheel housing liner → Rep. gr.66.

–  Place drip tray for workshop crane -VAS 6208- beneath engine. –  Pull connector -3- on the coolant temperature sender at radiator outlet off -G83- . –  Clamp off coolant hoses with hose clamps -3094-.

–  Release hose clips -arrows- and pull coolant hoses off right coolant pipe. –  Unscrew nut -1- and bolt -2-, and remove right coolant pipe. Installing l  Specified torques → Chapter. Installation is carried out in the reverse order; note the following:   Note Secure all hose connections with the correct type of hose clips (same as original equipment) → Electronic parts catalogue. –  Fill coolant system with coolant → Chapter.