seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Oil pressure switchF1: check > < Removing and installing oil filter bracket with oil cooler

Leon Mk2

Oil pressure switchF1: Removing and installing
Oil pressure switch -F1-: Removing and installing
t  Oil pressure switch -F1-: Removing → Anchor
t  Oil pressure switch -F1-: Installing → Anchor.
   
Removing .
–  Remove the engine cover upwards -arrows-.
  E10-10085
–  Remove the hose -1- from the vent on the crankshaft case. Press the unlocking buttons for this purpose.
–  Leave the vacuum hoses open -arrows-.
–  Remove air pipe from air filter housing; release hose clip -3- for this.
–  Unscrew bolt -2-, swing air pipe with inlet connection to rear and pull off from turbocharger.
  A21-10437
–  Unscrew bolts -2- and -3-, remove engine lifting eyes -1-.
–  Disconnect electrical connector -arrow-.
–  Remove oil pressure switch -F1-.
Fitting .
l  Tightening torques → Chapter
Installation is carried out in reverse order, noting the following:
  Note
Renew seal.
–  Install vacuum line to exhaust gas recirculation cooler → Chapter.
–  Installing intake pipe → Chapter.
  A17-10550

Oil pressure switchF1: check > < Removing and installing oil filter bracket with oil cooler