Leon Mk2
| Crankshaft: Assembly overview |
| 1 - | Bearing shell |
| q | For half-bearings 1, 2, 4 and 5 |
| q | Do not interchange used bearing shells (mark) |
| 2 - | 65 Nm + turn 90° further |
| q | Renewing |
| q | For measuring radial clearance, tighten to 65 Nm but do not turn any further |
| 3 - | Bearing caps |
| q | Bearing cap 1: Pulley side: |
| q | Bearing cap 3 with recesses for thrust washers. |
| q | Bearing shell retaining lugs (cylinder block/bearing cap) must be on the same side. |
| 4 - | Thrust washer |
| q | For bearing cap 3. |
| q | Note attachment |
| 5 - | Needle bearing |
| q | Vehicles with dual clutch gearbox only. |
| q | Removing and installing → Chapter |
| 6 - | Crankshaft |
| q | New axial play: 0.07 - 0.17 mm; Wear limit: 0.37 mm |
| q | Check radial clearance with Plastigage. |
| q | new: 0.03 - 0.08 mm Wear limit: 0.17 mm |
| q | Do not rotate crankshaft when checking radial clearance. |
| q | Crankshaft dimensions → Chapter. |
| 7 - | Thrust washer |
| q | For cylinder block, bearing 3 |
