seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Poly-V belt without air conditioner compressor: Assembly overview > < Tensioner for poly-V belt: Removing and installing

Leon Mk2

Vibration damper: Removing and installing
Vibration damper: Removing and installing
t  Vibration damper: Removing → Anchor
t  Vibration damper: Installing → Anchor.
t  Specified torques → Anchor.
Removing .
–  Remove the Poly V-belt → Anchor.
   
–  Remove centre noise insulation -fastening points 1 ... 3-.
  A10-1565
–  Remove right noise insulation -fastening points 1 ... 3-.
  A10-1643
–  Remove the vibration damper hood.
–  Unscrew the vibration damper. For this purpose, counterhold using a ring spanner.
  Note
To loosen and to tighten the vibration damper, hold it on the centre bolt using a ring spanner.
Fitting .
Installation is carried out in reverse order, noting the following:
–  Use new bolts.
  A13-0356
–  When installing the vibration damper, use only genuine bolts (same as original equipment): → Parts catalogue.
l  Fitting can only be completed in one position only: The hole -arrow- in the vibration damper must fit over the projection on the pulley.
Specified torques .
  A13-0134
ComponentNm
Vibration damper to crankshaft sprocket10 + 90° 1)2)
l  1) Renew bolts
l  2) 90° = one quarter turn

   

Poly-V belt without air conditioner compressor: Assembly overview > < Tensioner for poly-V belt: Removing and installing