SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4 cylinder Diesel engine (2.0 litre engine, Common Rail, Generation II) | Exhaust system | Silencer | Installation position and tightening torque of the clamping sleeve

Installation position and tightening torque of the clamping sleeve

Note

Gradual insertion of the clamping sleeves with integrated connecting bracket.

Tightening torque and installation dimension of the clamping sleeve

Clamping sleeve -A- with 2 separate connecting brackets.

Specified torque: 25 Nm.

Installation dimension -a-, 5 mm (only for the front clamping sleeve)

Clamp -B- with continuous clip.

Specified torque: 35 Nm.

Installation dimension -a-, 8.5 mm (only for the front clamping sleeve)

Installation dimension -a- for vehicles with markings on the front exhaust pipe.

1 -

Clamp

2 -	Primary exhaust pipe

a -	Installation dimension

A -

Marking

Installation position of front clamp

–	Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.

l	Bolted connection must point to the right.

Installation position of rear clamp

–	Install clamp so that end of bolt -arrow- does not extend beyond lower edge of clamp.

l	Screw thread must face rear

SEAT Workshop Service and Repair Manuals