seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Coolant pipe - front: Removing and installing > < Removing and installing coolant pipes (left-side)

Leon Mk2

Right coolant pipe: Removing and installing
Right coolant pipe: Removing and installing
   
Removal:
Proceed as follows:
–  Release fasteners -1- and -2- and remove noise insulation panel (front centre).
  A10-10761
–  Place drip tray for workshop cranes -TT20173- beneath engine.
–  Clamp off coolant hoses -arrows- with hose clamps -3094- and detach.
–  Remove bolts -1- and -2- and take off coolant pipe (right-side).
Installing
l  Tightening torques → Chapter
Reassembly is carried out in the reverse order; note the following:
–  Install the front noise installation.
  A19-10612
–  For this purpose, remove the fixing elements -1- and -2-.
–  Check coolant level → Anchor.
  A10-10761

Coolant pipe - front: Removing and installing > < Removing and installing coolant pipes (left-side)