SEAT Workshop Service and Repair Manuals

A - Fit the seal along with the sender wheel on the fitting device -T10134-

–  Tighten the hexagonal nut -B- to just before the threaded spindle attachment surface -A-.

–  Secure the fitting device -T10134- on the attachment surface -A- of the threaded spindle in a vice. –  Press down on the installation socket -C- so that it rests on the hexagonal bolt -B--arrow-. –  Screw hexagon nut onto threaded spindle until inner part of assembly device and assembly housing are at same height.

–  Remove securing clip -arrow- from new sealing flange.   Note Do not remove the sender crown from the sealing flange or change its position.

–  The locking hole -A- on the sender wheel -C- must coincide with the mark -B- on the sealing flange. –  Secure the sealing flange by the front on a flat, clean surface.

–  Press the sealing lip pressure ring -A- in the direction of the -arrow- downwards until it rests on the flat surface.

–  The upper edge of the sender wheel and the front edge of the sealing flange must coincide -arrows-.

–  Place the front of the sealing flange on the fitting device -T10134-, so that the position pin -B- fits into the hole -A- in the sender wheel.   Note Ensure sealing flange lies flat on assembly tool.

–  When tightening the knurled bolts -A- on the installation device -T10134-, press the sealing flange and the sealing lip pressure ring -B- so that the position pin does not come out of the hole in the sender wheel.   Note Ensure that the sender wheel remains secured in the fitting device when fitting the sealing flange.