seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
C - tightening the assembly deviceT10134 onto crankshaft flange > < A - Fit the seal along with the sender wheel on the fitting deviceT10134

Leon Mk2

B - Fit the installation deviceT10134 with the sealing flange on the crankshaft flange
B - Fit the installation device -T10134- with the sealing flange on the crankshaft flange
l  The crankshaft flange must be free of oil and grease.
l  The engine should be in TDC cylinder 1
   
–  Unscrew the hexagonal bolt -B- to the end of the threaded spindle.
–  Press the threaded spindle of the assembly device -T10134- in the direction of the arrow until the hexagonal nut -B- is in contact with the installation socket -A-.
–  Align flat side of assembly housing to crankcase's sealing surface on the oil sump side.
  N13-10045
–  Secure the fitting device -T10134- to the crankshaft flange; to do so, tighten the Allen bolts -A- about
  Note
Screw the Allen screws -A- by approx. 5 threads into the crankshaft flange.
  N13-10044
–  Screw in the 2 bolts M6×35 mm -A- on the engine block to guide the sealing flange.
  N13-10031

C - tightening the assembly deviceT10134 onto crankshaft flange > < A - Fit the seal along with the sender wheel on the fitting deviceT10134