| Parts of the exhaust system: Removing and installing |
Note | t
| After working on the exhaust system, ensure that the system is not under stress and that there is sufficient clearance to the bodywork. If necessary, loosen double and single clamps and align silencer and exhaust pipe so that sufficient clearance is maintained to the bodywork and the weight is evenly distributed over the supports. |
| t
| Renew self-locking nuts. |
| t
| The exhaust manifold and the turbocharger are combined as one unit; removing and installing. |
| Catalytic converter and attaching parts - Assembly overview → Chapter |
| Lambda probe after catalytic converter -G130- and Heater for lambda probe 1, after catalytic converter -Z29- → Chapter. |
| Main catalytic converter with exhaust pipe: removing and fitting → Chapter |
| Lambda probe -G39- and Lambda probe heater -Z19- before catalytic converter removing and fitting → Chapter |
| Separate the centre and rear silencers → Chapter. |
| Separate the centre and rear silencers → Chapter. |
| Exhaust system: Align free of tension → Chapter. |
|
|
|
