Leon Mk2
Sealing flanges - Assembly overview . |
1 - | 15 Nm |
2 - | Seal |
q | replace → Chapter |
q | Do not use oil |
3 - | Sealing flange on the pulley side: |
q | Must sit on dowel sleeves |
q | Removing and installing → Chapter |
q | Mount with sealant → Parts catalogue |
4 - | cylinder block |
q | Removing and installing crankshaft → Chapter. |
q | Piston and rod: disassembly and assembly → Chapter |
5 - | 60 Nm + 90° (1/4 turn) |
q | replace |
6 - | Dual mass flywheel or drive plate |
q | Removing and installing dual-mass flywheel → Chapter. |
q | Drive plate: removing and installing → Chapter |
q | Assembly is possible only in one position, as the holes are offset |
7 - | Intermediate plate |
q | Must sit on dowel sleeves |
q | Do not damage or bend when assembling. |
q | Is fitted onto sealing flange → Fig. |
8 - | 15 Nm |
9 - | Sealing flange on flywheel side |
q | Can be replaced complete with oil seal. |
q | Removing and installing → Chapter |
q | Use the provided guide sleeve for installation. |
q | Do not grease or oil the seal lip of the seal |
q | Before the installation, clean the remains of oil on the crankshaft journal using a clean cloth. |
q | The guide sleeve should only be removed after fixing the sealing flange on the crankshaft journal |
|