seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Conversion table by relevance > < Ignition system: removal and fitting

Leon Mk2

Removing and installing ignition coils with output stages
Removing and installing ignition coils with output stages
t  Removing → Anchor.
t  Installing → Anchor.
Special tools and workshop equipment required
   
t  Extractor -T40039-, see equivalent → Anchor
  Note
t  In order to extract the spark plugs, fit the extractor -T40039- into the upper large groove -arrow- on the ignition coils with final power output stage.
  W00-1303
t  If the lower grooves are used, damage may occur.
Removing
  A02-0392
–  Release quick fasteners -arrows- and remove engine cover panel.
  E10-10065
–  Unscrew the earth wire -2-.
–  Unplug the electrical connectors -3- and move wiring clear.
–  Pull out ignition coils -1-.
  Note
  A15-0574
Remove ignition coils using the extractor -T40039-.
Installing
–  Press with a hand the ignition coil with output stage onto the spark plug.
–  Connect the connector to ignition coils.
  A28-0074

Conversion table by relevance > < Ignition system: removal and fitting