seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing radiator fanV7 and radiator fan?2V177 > < Removing and installing radiator fan control unitJ293

Leon Mk2

Removing and installing radiator cowl
Removing and installing radiator cowl
t  Removing → Anchor
t  Installing → Anchor
t  Tightening torques → Anchor
   
Removing
–  Loosen the fasteners -2-, -3- and -5- and remove the front noise insulation.
–  Remove the front bumper trim → Rep. gr.63.
–  Move lock carrier to service position → Rep. gr.50.
  A10-1307
–  Detach the electrical connectors -1- and -2- from the bracket and unplug them.
–  Move electrical wiring clear.
  A10-10282
–  Separate the plug connections -1- at the turbocharger pressure sensor and place the cables to one side.
–  Unscrew bolts -arrows- and lift out the radiator cowl upwards together with the control unit.
Installing
Installation is carried out in the reverse sequence; note the following:
–  Install lock carrier with attachments → Rep. gr.50.
  A19-10153
–  The torque reaction support must set itself on its rubber stop by means of its self weight, then tighten the nuts -arrows-.
–  Install the front bumper trim → Rep. gr.63.
Tightening torques
  A10-10288
ComponentNm
Radiator cowl toM611
Lock carrier:Self-tapping screw2
Stop for torque reaction support to lock carrier28
Hose clips (9 mm wide)3
Hose clips (13 mm wide)5,5

   

Removing and installing radiator fanV7 and radiator fan?2V177 > < Removing and installing radiator fan control unitJ293