Leon Mk2
Note
|
| 1 - | cylinder block |
| 2 - | Bearing shell for cylinder block |
| q | With oil groove |
| q | Do not interchange used bearing shells (mark). |
| q | Classification of crankshaft bearing shells → Chapter |
| 3 - | Crankshaft |
| q | After removing, place it down so that the impulse sender wheel does not rest - risk of damage |
| q | If crankshaft is renewed, new bearing shells must be assigned to bearing caps → Chapter |
| q | Axial clearance → Chapter |
| q | Radial clearance → Chapter |
| q | When measuring the radial play, do not rotate the crankshaft |
| q | Crankshaft dimensions → Chapter |
| 4 - | Bearing shell for bearing cap |
| q | Without oil groove |
| q | Do not interchange used bearing shells (mark). |
| q | Classification of crankshaft bearing shells → Chapter |
| 5 - | Bolt. |
| q | Replace |
| q | Tightening sequence → Fig. |
| 6 - | Bearing cap |
| q | Bearing cap 1: belt pulley end. |
| q | Bearing shell retaining lugs in cylinder block and bearing caps must align. |
| 7 - | Bolt. |
| q | 10 Nm and then turn 90° further |
| q | Replace |
| q | Replace the sensor wheel each time the screws are loosened → Chapter |
| 8 - | Generator wheel: |
| q | For engine speed sender -G28- |
| q | Can only be installed in one position (out of step bolts) |
| q | Sender wheel must be renewed if bolts are loosened |
| q | Removing and installing → Chapter |
| 9 - | Thrust washers |
| q | For bearing 3 |
| 10 - | Bolt. |
| q | Replace |
| q | Tightening sequence → Fig. |
