–
| Attach the counterhold tool -10 201- before loosening bolts. |
Caution Risk of damaging the outer surface of the mounting flange for the flywheel. |
Use a multi-point socket bit with a length of at least 40 mm to slacken and tighten the bolts of the flywheel. |
|
–
| Unscrew the bolts and take off flywheel as well as the sender wheel. |
Installation is carried out in the reverse sequence; note the following: |
Note t
| Renew bolts for flywheel. |
t
| A needle bearing is fitted in the flywheel. Before installing, check that the needle bearing is fitted. Move the needle bearing of the flywheel in and out with force → Chapter. |
–
| Pay attention to dowel pin when installing flywheel. |
–
| Fit counterhold tool -10 201- the other way round to tighten bolts. |
|
|
|