Leon Mk2
Intake manifold - exploded view |
1 - | Screw for intake air temperature sender -G42- |
q | 5 Nm |
2 - | Intake air temperature sender -G42- |
3 - | Activated charcoal filter solenoid valve 1 -N80- |
q | With dual non-return valve |
4 - | Intake manifold |
q | Removing and installing → Chapter |
5 - | Vacuum unit for air flow control flaps (intake manifold flaps) |
6 - | Bolts for high-pressure pump |
q | Replace |
q | 10 Nm |
7 - | Connecting piece for fuel supply line |
q | From fuel tank |
8 - | Fuel pressure regulating valve -N276- |
9 - | Mechanical single piston high pressure pump |
q | With fuel pressure regulating valve -N276- |
q | An electric fuel pump (fitted in fuel tank) supplies fuel to the mechanical high-pressure pump |
q | When installing the high-pressure fuel pump, it is essential to ensure that no dirt enters the fuel system. |
q | The fuel system must not be under pressure when installing the high-pressure pump; procedure for reducing fuel pressure → Chapter |
q | Fuel pipes must be free of tension when installed. |
q | Removing and installing → Chapter |
10 - | Roller tappet |
q | May remain stuck inside exhauster pump after removal of high-pressure pump, but can be removed |
11 - | Connecting piece for fuel supply line |
q | Replace |
q | 25 Nm |
12 - | High-pressure fuel pipe |
q | Fuel pipes must be free of tension when installed. |
q | 20 Nm |
13 - | Intake manifold flap valve -N316- |
14 - | Injectors |
q | Renew O-ring and Teflon ring |
q | Ensure correct installation position |
q | Removing and installing → Chapter |
15 - | Hose for intake manifold |
16 - | Bolt. |
q | For intake manifold support |
q | 23 Nm |
17 - | Securing nut for intake manifold support |
q | 10 Nm |
18 - | Bolts for throttle valve module -J338- |
q | 5 Nm |
19 - | Throttle valve module -J338-, throttle valve drive for electric throttle -G186- |
q | Throttle valve drive angle sender 1 for electric throttle -G187- and throttle valve drive angle sender 2 for electric throttle -G188- |
q | Throttle valve module -J338- must be re-adapted to engine control unit -J623- after it has been removed, installed or renewed; see → Vehicle diagnostic, testing and information system VAS 5051„Guided Functions“ |
20 - | Seal |
q | Replace |