Leon Mk2
Cooling system components, bodywork side - Assembly overview part 2 |
1 - | Radiator |
q | Removing and installing → Chapter |
q | Renew coolant after replacing cylinder head gasket |
2 - | O-ring |
q | Replace. |
3 - | Upper coolant hose |
q | Secured to radiator with retaining clips |
q | Ensure correct seating |
q | Coolant hose schematic diagram → Chapter |
4 - | Coolant hose |
5 - | Air duct |
6 - | 10 Nm |
7 - | Staple |
q | Ensure correct seating |
8 - | Bracket |
q | For the electric ventilator |
9 - | Electrical connector |
10 - | Radiator fan |
11 - | Runs to the thermostat housing |
q | Coolant hose schematic diagram → Chapter |
12 - | Expansion tank |
q | Perform cooling system leakage check with cooling system tester -V.A.G 1274- and the adapters -V.A.G 1274/8-. |
13 - | Filler cap |
q | Check using the cooling system tester -V.A.G 1274- and the -V.A.G 1274/9- adapter |
q | Opening pressure: 1.4 - 1.6 bar |
14 - | Lower coolant hose |
q | Secured to radiator with a clamp |
q | Ensure correct seating |
q | Coolant hose schematic diagram → Chapter |
15 - | Radiator fan thermoswitch -F18-, 35 Nm |
q | For the electric ventilator |
Switching temperatures |
q | 1st stage turn on: 92 ... 97 ?, Turn off: 84 ... 91 ? |
q | 1st stage turn on: 99 ... 105 ?, Turn off: 91 ... 98 ? |
16 - | Bracket |
q | For radiator |
q | Note fitting position: |
q | Note that there are various versions |
17 - | 10 Nm |