| Fuel supply system components: Removing and installing |
Note | t
| The connections for the flexible tubes are secured using spring type clips or screw clips. |
| t
| Always replace clamp-type clips with spring-type clips. |
| t
| The fuel hoses in the engine compartment must only be attached with plastic clamps. The use of clamp or screw-type clips is not permissible. |
| t
| Hose clip pliers -VAS 6340- are recommended for fitting spring-type hose clips. |
| t
| After removing the filter, the pump or the fuel distributor, the fuel supply system must be bled → Chapter. |
| t
| Fuel tank and fuel filter with components - Components overview. → Chapter |
| t
| Safety precautions when working on fuel supply system → Chapter |
| t
| Fuel delivery unit: removing and installing → Chapter |
| t
| Fuel gauge sender: removing and installing → Chapter |
| t
| Fuel tank: removing and installing → Chapter |
| t
| Fuel pump and fuel system: checking → Chapter |
| t
| Injection quantity and injector seal of the injection valve: check → Chapter |
| t
| Check the pressure regulator of the fuel and the holding pressure → Chapter |
| t
| Fuel delivery system: purging the air. → Chapter |
|
|
|
