Remove and install components of the exhaust system |
Note t
| The connecting elements of the front exhaust pipes must not be bent more than 10°, otherwise they could be damaged. |
t
| Always gaskets and self-locking nuts. |
t
| After completing work on the exhaust system ensure that it is tension-free and remains at a sufficient distance from the bodywork. If necessary, loosen the clamping bracket and align the silencer with exhaust pipe so that there is always a sufficient clearance from the bodywork and is evenly distributed over the suspension elements. |
t
| The exhaust manifold and the turbocharger make up a single part, removing and fitting → Chapter. |
Fuel tank, vehicles with front wheel drive installation overview → Chapter |
Fuel tank, vehicles with front wheel drive installation overview → Chapter |
Separate the centre and rear silencers → Chapter. |
Removing and installing Lambda probe -G39- and Lambda probe heater -Z19- before catalytic converter → Chapter |
Removing and installing Lambda probe after catalytic converter -G130- and Lambda probe 1 heater after catalytic converter -Z29- → Chapter |
Catalytic converter with main exhaust pipe: removing and installing → Chapter. |
Fit and align exhaust system free of stress → Chapter. |
|
|
|